Brix Campers Z Camper trailer review
Date: 25.07.2012
|
|
The Brix Z Camper presents clean lines in two-pack grey.
|
|
|
The roof carries a solar panel and rack.
|
|
|
There is plenty of storage room opposite the fridge.
|
|
|
The kitchen is very ergonomically designed.
|
|
|
The tent is roomy, with easy access to the bed.
|
|
|
The 100Ah batteries are easily accessible.
|
|
|
The tent has room for a couple to eat out of the elements.
|
A unique roof puts the Brix Z Camper in a category of its own.
|
|
The full awning shades, the tent, and the front of the Brix Z Camper.
|
RICK NICHOLLS AND Brett Nicholas have been keen campers all
their life and offroad enthusiasts for just a bit less. They are
both engineers and when they decided their business needed to
change direction they started building something for which they had
a passion: camper trailers. The Brix Z Camper is the result and it
is certainly a unique design.
The trailer is built on a fully galvanised chassis with a drawbar
that is 3600mm long, from towball to axle centerline. This means
the trailer is very maneuverable, easy to reverse and that you will
be able to open your car boot, no matter how big the door. The loss
of departure angle that comes with a longer drawer is mitigated by
the airbag suspension.
This suspension setup is of the guys' own design and works like a
charm, allowing you to adjust the height of both sides separately
at the press of a button. Plus you have a built in tyre compressor
at your fingertips. It has replaceable 60mm axles, so the trailer
wheels can be matched to any tow vehicle's track or bolt
pattern.
But the uniqueness of this trailer lies in the bonded and welded
marine-grade aluminium body and the way in which it opens. The top
of the trailer lifts from the front and is supported by two posts,
and a metal frame beneath this lifts from the back and is again
supported by two posts. This creates a surprising amount of room
above the innerspring queen bed, and it goes up in a minute or so,
giving an insulated hard roof.
Then you lift the rear canvas out over the tailgate and pull it out
on the ground behind, step in through one of the side doors and
lower the tailgate, which has an inbuilt step, then assemble the
bow which supports the end of the tent and secure with two guy
ropes. Finished.
The tent has three large screened windows at the rear and three
around the bed. The floor area provides room for two kids' beds or
a table and chairs, with doors at the front for easy bed
access.
When collapsed the trailer body is 1500mm tall, with lots of
storage under the bed and 200mm above it to carry all manner of
items.
Brett and Rick both have families, and figured they wanted the ease
of a hardfloor setup with a softfloor's storage capacity. It had to
have room to sleep a couple of kids and provide a high level of
fitout. And their solution is a mix of pop-top, hard floor and soft
floor.
If the Brix Z Camper has one primary selling point it's the ease of
set up for basic camps. Within five minutes you can have a very
livable site. As with all camper trailers, if you want the whole
annexe with walls then it will take longer.
The awning comes in two pieces; an L-shaped one that zips around
the front of the tent and along the offside, and another that zips
across the back and joins up with the other, in the process acting
as a tropical roof for the tent. This has to be removed when
packing up, and it will require a set of steps because of the
height of the roof, but with all that storage room it shouldn't be
a problem, especially seeing as you end up with a massive covered
area of 2x8m.
The stainless steel kitchen unit pulls out of the front of the
offside. There's a sink with an electric tap and a four-burner
Spinflo with a grill. The storage for your pots and utensils is an
open fronted cupboard under the work space, with the guys advising
you to carry cutlery in a cloth roll, as they feel a drawer is not
an efficient use of storage space.
The kitchen also comes with a pull-out pantry drawer on the rear
and a 60L ARB fridge/freezer on a slide in front.
The trailer comes equipped with an excellent electrical system.
Based on two 100Ah AGM batteries, it offers pretty much everything
you could ask for (see comparo for details), including a 120W solar
panel affixed to the roof. Lighting includes an LED interior light
and two LED reading lights in the roof.
The camper comes equipped with an 82L water tank and gauge and one
of the options is a second 60L tank at the front.
Outside it's finished in grey two-part polyurethane paint, and
inside it uses Rhino Lining for its wipe-over practicality. The
roof is adorned with Rola roof racks, so you can carry your
favourite toys.
SUMMING UP
The Brix Z Camper comes at a time when the budget end of the market
is feeling the squeeze from cheap imported products, but this
camper costs $39,500 as tested, with a three-year warranty, and is
clearly aimed towards the more discerning buyers. It promises
durability and comfort, with a high level of fitout for the price.
If you're looking to shell out that amount of dough then I would
definitely advise you to have a look at this camper
trailer.
SPECIFICATIONS
Brix Z Camper
Tare: 950kg
ATM: 1500kg
Suspension: Independent airbag
Brakes: 10in electric drum
Coupling: McHitch
Price (as shown): $39,500
Contact: Brix Campers, 2/10 Sturt St, Smithfield, NSW 2164, (02)
9632 2388, http://www.brix.com.au/
Source: Camper Trailer Australia #51
